When using a sticky dust pad, the following points should be noted:

1. When using a sticky dust pad, first peel off the protective layer of the adhesive surface from the opening on the back, and then stick it flat on the floor when entering and exiting. The floor must be dry and there should be no water marks.

2. After pasting, use the sole of the shoe to flatten the sticky dust pad on the ground, and then tear off the protective layer on the surface of the sticky dust pad from the front opening.

3. After the surface of the film is covered with dust during use, the viscosity of the adhesive pad will decrease. At this time, it is necessary to tear off this layer of adhesive pad. Tearing off the adhesive pad is also important. First, slowly separate the four corners of the adhesive pad from the pad, then move towards the middle to wrap all the dust inside. Fold the film inward until it is small enough to be discarded. This can ensure that the pollutants attached to the adhesive pad do not fly around and ensure the dust removal effect.